Alarm Properties

Properties

ActiveTags Gets the latest set of measurement keys that cause the Alarm to be raised.
Cause Gets the most recent frame that caused the alarm to be raised.
Combination Gets or sets the combination logic of the alarm.
CreateAssociatedMeasurement Gets or sets flag to indicate that a measurement should be created for this alarm.
Delay Gets or sets the amount of time that the signal must be exhibiting alarming behavior before the alarm is raised.
Description Gets or sets the description of the alarm.
Enabled Gets and Sets Enabled flag
Hysteresis Gets or sets the hysteresis used when clearing alarms. This value is only relevant in greater than (or equal) and less than (or equal) operations.
ID Gets or sets the identification number of the alarm.
InputMeasurementKeys Gets or sets the identification the measurements used to trigger the Alarm.
Operation Gets or sets the operation to be performed when testing values from the incoming signal.
SetPoint Gets or sets the value to be compared against the signal to determine whether to raise the alarm. This value is irrelevant for the Flatline operation.
Severity Gets or sets the severity of the alarm.
SignalID Gets or sets the identification number of the the measurements generated for alarm events.
State Gets or sets the current state of the alarm (raised or cleared).
TagName Gets or sets the tag name of the alarm.
Timeout Gets or sets the Timeout in seconds at which the alarm stops if no data comes in.
TimeRaised Gets or sets the timestamp of the most recent measurement that caused the alarm to be raised.
Tolerance Gets or sets a tolerance window around the SetPoint to use when comparing against the value of the signal. This value is only relevant for the Equal and NotEqual operations.

See Also